Step 1: Pour electrolytic water into the tank

Step 2: Let the engine flamed out, open the engine hood, then connect vacuum tube

Step 3: Start the car and let car run at idle
Step 4: Plug in power and turn on power switch
Step 5: Start the machine
Step 6: Set time (20 mins for suggestion)
Step 7: Adjust gas production. (Then the machine is working, and start to clean carbon)
Step 8: After finishing, turn off the machine
Step 9: Turn off power switch
Step 10: Let the car run at idle for one minute, then flamed out, and recover vacuum tube.

Step 11: Start the car, under at idle, speed up to 3000-3500 RPM, then let go of the throttle. After 3 seconds, speed up again. Repeat six times like this. The dirt in exhaust pipe will be ejected out.

Previous--Next