1, the cell will be reduced after a period of time, such as when used normally found enough pressure can be added to water to keep the water level in the normal work, do not join the mineral water. (Need to add the first use of electrolytic powder)

2. Water welder for the first time you need to configure the electrolyte, after the course can just add water, electrolyte recommended three months or so updated and better results.

3. Water welder should add water and change the water after the first turn off the flame gun and power, then open flame gun switch until all remaining gas is discharged into the machine, add water slowly unscrew the nuts add water to no more than "high scale" is not below the "low-scale" position, tighten the nut back on.

4. When the water filtration tank welder add water or alcohol, you must first extinguish the torch of fire, and then use the remaining gas discharge port machine gun inside, after determining the gas within the machine completely discharged before unscrewing canister conduct operating

5, if the water in the hose can cause yellow flame, should be discharged.

6. Check the hose connection not leak.

7. Water welder above do not place any metal objects and liquids, in order to avoid short circuits and other security problems.

8. When water welder debugging and electrolyte replacement, please do security. Electrolyte is non-toxic, but is corrosive to skin and eye burns force, if accidentally touched, immediately rinse with water.

Previous--Next