① quality of the equipment used is pure water, prohibit the use of tap water.

② In addition to carbon before, should ensure that there is enough fuel car can run idle for about 60 minutes.

③ system when in standby mode, as detected level is not enough, it rings for Dosing, please add liquid carbon solution [except] when the ringing stopped, should stop dosing.

④ In addition to the carbon before starting the device ensure that both valves in a closed valve, the valve 2 open.

⑤ strict attention to the distinction between petrol and diesel vehicles in addition to the carbon in the process of valve change: carbon removal process in gasoline, the valve 1 and 2 are kept open; diesel valve 1 remains open process in addition to carbon, the valve 2 remain closed.

⑥ Please note that carbon cleaing  end after holding a closed valve, the valve 2 open.

⑦ abnormalities such as machinery, should immediately press the F6 key to auto exhaust, and then turn off the machine power.

⑧ after the engine is started, whether during or after addition to carbon in addition to carbon end, turn off the engine if found, to prohibit re-start the engine. Please use the compressed air intake pipe vacuum tube gasoline or diesel vehicles three minutes, the engine will go into the residual gas is blown, and the vehicle was allowed to stand 10 minutes before launch again.

⑨ Please pulley position of the selected device after the device is placed in a fixed position (each pulley has jammed pulley function) to prevent equipment slippage due to unforeseen circumstances.

⑩ equipment working environment is recommended to maintain good ventilation.

Previous--Next