① water quality of the equipment used for pure water, prohibit the use of tap water.

② before carbon cleaning, should ensure that there is enough fuel cars can run idle for about 60 minutes.

③ When the system in standby mode, as detected by the level is not enough, will be prompted to add liquid ring, please add liquid carbon cleaning solution [], when the ringing stopped, should immediately stop dosing.

④ carbon cleaning before the start of the two valves make sure that the equipment is in a closed valve, the valve 2 open.

⑤ strict distinction gasoline and diesel valve changes in carbon cleaning process: in gasoline carbon cleaning process, the valves 1 and 2 are kept open; a diesel valve remains open in carbon cleaning process, the valve 2 remain closed.

Please note that after the end of ⑥ carbon cleaning to maintain a closed valve, the valve 2 open.

⑦ abnormalities such as machinery, should immediately press the F6 key to auto exhaust, and then turn off the machine power.

⑧ after the engine is started, whether it is carbon cleaning process or after the carbon cleaning, turn off the engine if found, to prohibit re-start the engine. Use compressed air to blow the intake manifold vacuum gasoline or diesel vehicles in three minutes, the engine will go into the residual gas is blown, and stand 10 minutes before launch vehicle again.

⑨ pulley position in the selected location of the device after the device is placed in a fixed (each pulley sheaves has stuck function), to prevent the equipment due to unforeseen circumstances arise slide.

⑩ equipment working environment is recommended to keep good ventilation.

Previous--Next